The process flow of the shock absorber assembly:
1. In order to detect the shape of the shock absorber, the rubber should not appear in the cracked mouth, rubber and metal separation parts, and the effective time should be observed according to the temporary technical rod provided by the shock absorber.
2. According to the design of the auxiliary shock absorber, place the shock absorber on the upper side of the base and observe the joint state of the shock absorber and the supporting surface of the base. It requires not to insert a zero point one millimeter thick plug, and some positions can be inserted into zero to zero two millimeter thick plugs, but the type of insertion cannot be greater than the shock absorption. The bottom circumference of the device is 35 percent, and its depth cannot be greater than 20 mm.
3. At the same time, tighten the bolt holes of the shock absorber on the base. Under larger batch conditions, the sample plate can be prepared according to the base of the machine, and the sample is placed at the required position on the support surface of the base. After the bolt hole, the drilling is started. If it is one or a small batch, this time can be temporarily installed on the base of the auxiliary machine, and then the auxiliary and shock absorber are hoisted to the seat, and the position of the shock absorber is correctly placed according to the requirements of the drawing and the bolt HO. The LES on the shock absorber crosses the base. Then, hang the auxiliary machinery on the shock absorber and punch holes in the base.
4. Tighten the bolts and fasten the shock absorber to the base.
5. Lift the auxiliary machine, lift the jack, or the screw to the required height, and measure the distance between the shock absorber sleeve plane and the base, which is more than twice the diameter of the fastening bolt.
The shock absorber is installed by changing the interference force of the vibration source or the transmission and performance of the system to reduce vibration. Shock absorbers are classified from the perspective of monks' raw materials. It is divided into two types of hydraulic shock absorbers and hydraulic shock absorbers, and the other is a variable damper with a damper.
